So the DWM1001-dev board says it uses the I2c connections as well, so this would interfere with the AI hat+ board? Or is there a way to set up the DWM1001 to not use I2c? I would add in the connections chart picture but I do not know how to insert a photo, the datasheet for the dwm1001 is on this page: https://www.qorvo.com/products/p/DWM1001-DEV Just to clarify for my understanding, I2c, UART, SPI are all types of communication between boards, if the board says it can use UART instead of I2c, why does the board require to be connected to the I2c pins, and if theres issues clashing between these two boards, am I able to run the DWM1001 board to just offboard its serial data (ie the value it reads from the tag it is finding the distance of) just through certain pins instead of fully connected by ribbon cable?
Thanks again for everyone's help, I know I'm diving into the deep end of this without prior experience, going to be a tough learning curve.
Thanks again for everyone's help, I know I'm diving into the deep end of this without prior experience, going to be a tough learning curve.
Statistics: Posted by Tomtomtom839 — Tue Dec 24, 2024 3:46 pm
