So I figured it out but this surely isn't the best way to fix this.
I edited the config.txt and disabled a lot of things
I edited the config.txt and disabled a lot of things
Code:
# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected cameras# camera_auto_detect=1# Automatically load overlays for detected DSI displays# display_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driver# dtoverlay=vc4-kms-v3d# max_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.# disable_fw_kms_setup=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[cm5]dtoverlay=dwc2,dr_mode=host[all]Statistics: Posted by DarkElvenAngel — Sun Nov 09, 2025 1:50 am