Hmm.. I'm showing no overlays loaded? dtoverlay=vc4-kms-v3d is there by default and added the vc4-kms-dsi-7inch for touch
But dtoverlay -l says no overlays loaded.
I get an error when trying to load it manually too. Well I did the first time I just tried again to see the error and it loaded.
Holy crap
So I tried disp0 again but added ",dsi0" to the dtoverlay (some threads suggested it but docs didn't) and now it's working.
I am wondering though if I fried some i2c on ch0? I never saw 45 come up on disp1...
It's working with touch though. Might be flipped versus touch but I'm sure that's easy.
Thanks, now that it comes up on the cm4io I can go back and verify if I fried a bus or not. Couldn't get the rtc to show either, ugh.
Now my only issue is that it's shifted up like 10 pixels (top 10px is cut off, bottom 10px is black)
But dtoverlay -l says no overlays loaded.
I get an error when trying to load it manually too. Well I did the first time I just tried again to see the error and it loaded.
Holy crap
So I tried disp0 again but added ",dsi0" to the dtoverlay (some threads suggested it but docs didn't) and now it's working.
I am wondering though if I fried some i2c on ch0? I never saw 45 come up on disp1...
It's working with touch though. Might be flipped versus touch but I'm sure that's easy.
Thanks, now that it comes up on the cm4io I can go back and verify if I fried a bus or not. Couldn't get the rtc to show either, ugh.
Now my only issue is that it's shifted up like 10 pixels (top 10px is cut off, bottom 10px is black)
Statistics: Posted by forbiddenera — Wed Aug 27, 2025 4:43 pm