Interfacing (DSI, CSI, I2C, etc.) • Is this the way to wire a Rpi3 to a RED SPI LCD? (not waveshare)

Hello rpi users

I am trying to wire my Raspberry Pi 3 to a new RED LCD ili9486, so that it would have the same GPIO used as the waveshare 3.5" LCDs

Would you think this is a good wiring diagram?

I am still researching what dtoverlay parameters to add in the /boot/firmware/config.txt file

References:
https://www.waveshare.com/wiki/4inch_RPi_LCD_%28A%29
http://www.lcdwiki.com/4.0inch_SPI_Module_ILI9486

Statistics: Posted by robertojguerra — Mon Jun 23, 2025 1:48 am

---