Thanks ghp - I'm collaborating with Mampir. To confirm, did you receive the Pico 2 WH, specifically with the JST debug connector?
I had assumed the height of the underside of the black part of the headers to the underside of the PCB would be 2.54mm, as that is quite typical. Can you confirm whether it is specifically 2.6mm or 2.54mm?
Also, I see from Raspberry Pi's datasheet for the JST debug connector, that its height is typically 4.25mm. Could you also confirm whether from the board surface to the debug connector surface is specifically 4.1mm or 4.25mm?
Additionally, if you have the time, it would be very helpful to know "x", "y", and "w" in the image below (we are working on 3D models for the built-in KiCad library, so your measurements are a helpful contribution!) I also add 2 more pictures to explicitly confirm the locations of the measurements you provided.
Thank you!
I had assumed the height of the underside of the black part of the headers to the underside of the PCB would be 2.54mm, as that is quite typical. Can you confirm whether it is specifically 2.6mm or 2.54mm?
Also, I see from Raspberry Pi's datasheet for the JST debug connector, that its height is typically 4.25mm. Could you also confirm whether from the board surface to the debug connector surface is specifically 4.1mm or 4.25mm?
Additionally, if you have the time, it would be very helpful to know "x", "y", and "w" in the image below (we are working on 3D models for the built-in KiCad library, so your measurements are a helpful contribution!) I also add 2 more pictures to explicitly confirm the locations of the measurements you provided.
Thank you!
Statistics: Posted by recursivenomad — Mon May 05, 2025 5:37 pm