That does not workAs rpdom said above, these are all separate overlays and need to be on separate lines for each overlay.Code:
...[all]dtoverlay=spi0-0cs,i2c1-pi5,i2c0-pi5,uart1-pi5dtparam=uart0=on...Code:
...[all]dtoverlay=spi0-0csdtoverlay=i2c1-pi5dtoverlay=i2c0-pi5dtoverlay=uart1-pi5dtparam=uart0=on...
Code:
fred@pi5:~ $ ls /dev/i2c-*/dev/i2c-1 /dev/i2c-11 /dev/i2c-12fred@pi5:~ $ Code:
fred@pi5:~ $ ls /dev/i2c-*/dev/i2c-1 /dev/i2c-11 /dev/i2c-12fred@pi5:~ $ cat /boot/firmware/config.txt # For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfacesdtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[cm5]dtoverlay=dwc2,dr_mode=host[all]dtoverlay=spi0-0csdtoverlay=i2c1-pi5dtoverlay=i2c0-pi5dtoverlay=uart1-pi5dtparam=uart0=onfred@pi5:~ $ Statistics: Posted by foxsquirrel — Sun Feb 23, 2025 5:15 am