Hello.
Will Raspberry Pi M.2 HAT+ work with Xiwai M-Key PCIe SATA JMB585 (https://pipci.jeffgeerling.com/cards_st ... -sata.html) ? ACT LED in HAT+ does not light, only the PWR diode is lit red. I don't see controler SATA. After turning on PI, the LEDs in the SATA controller will flash once.
I have HAT+, and i see only this:Thx for answer
Will Raspberry Pi M.2 HAT+ work with Xiwai M-Key PCIe SATA JMB585 (https://pipci.jeffgeerling.com/cards_st ... -sata.html) ? ACT LED in HAT+ does not light, only the PWR diode is lit red. I don't see controler SATA. After turning on PI, the LEDs in the SATA controller will flash once.
I have HAT+, and i see only this:
Code:
00:00.0 PCI bridge: Broadcom Inc. and subsidiaries Device 2712 (rev 21) (prog-if 00 [Normal decode]) Flags: bus master, fast devsel, latency 0, IRQ 39 Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 Memory behind bridge: 00000000-005fffff [size=6M] [32-bit] Prefetchable memory behind bridge: [disabled] [64-bit] Capabilities: <access denied> Kernel driver in use: pcieport01:00.0 Ethernet controller: Device 1de4:0001 Flags: bus master, fast devsel, latency 0, IRQ 39 Memory at 1f00410000 (32-bit, non-prefetchable) [size=16K] Memory at 1f00000000 (32-bit, non-prefetchable) [virtual] [size=4M] Memory at 1f00400000 (32-bit, non-prefetchable) [size=64K] Capabilities: <access denied> Kernel driver in use: rp1Statistics: Posted by klaczek — Sun Jun 16, 2024 1:30 am